(UTC)
  Lantica User Forum › Archived Topics › Archived Topics › Programming for execution
(Moderator: Forum Admin)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send Topic Send Topic Print Print
Normal Topic Programming for execution (Read 457 times)
Bharat_Naik
Senior Member
Members
*****
Offline


Ever ready to learn and
share

Posts: 1202
Location: Chicago,  Illinois
Joined: Dec 16th, 2003
Programming for execution
Feb 2nd, 2004 at 3:33pm
Print Post Print Post  
Is there any programing of passing certain Key strokes or you Macro is the only way?

When you use @LoadMassUpdateSpec ( ) or @LoadRetrieveSpec ( ), it just Loads and one has to use <alt R> key to execute.  It does not make sense to just store a macro, load a macro and run a macro for one key.  I do not know about others but I am reluctant to use macro to record mouse clicks.

  
Back to top
 
IP Logged
 
The Cow
YaBB Administrator
*****
Offline



Posts: 2530
Joined: Nov 22nd, 2002
Re: Programming for execution
Reply #1 - Feb 2nd, 2004 at 4:10pm
Print Post Print Post  
Instead of using Alt-R (which depends on which spec is being viewed), try using SelectTreeItem - to launch the loaded spec. Most of the "spec launching" commands appear under the "Results Commands" branch of the Command Tree.
  
Mark Lasersohn&&Programmer&&Lantica Software, LLC
Back to top
WWW WWW  
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Send Topic Print Print
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

Lantica User Forum » Powered by YaBB 2.6.11!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge