(UTC)
(Moderator: Forum Admin)
‹ Previous Topic | Next Topic ›
Page Index Toggle Pages: 1 Send Topic Send Topic Print Print
Normal Topic Mass Update Spec (Read 446 times)
NICEBERG
Full Member
Members
***
Offline


I came, I saw, I'm still
trying to figure it out!

Posts: 208
Location: Green Bay, WI
Joined: Dec 17th, 2003
Mass Update Spec
Dec 31st, 2005 at 7:19pm
Print Post Print Post  
I've done mass updates before - no problem. However, today when I try to access the Mass Update Spec it is "greyed out". I can't access any of the elements to type in my programming statement. I'm following the steps on pages 264-267 but can't get past step 2.

I AM able to do what I want in the SDesigner Preview Application. Confused - again  ???
  
Back to top
 
IP Logged
 
NICEBERG
Full Member
Members
***
Offline


I came, I saw, I'm still
trying to figure it out!

Posts: 208
Location: Green Bay, WI
Joined: Dec 17th, 2003
Re: Mass Update Spec
Reply #1 - Dec 31st, 2005 at 8:08pm
Print Post Print Post  
Tongue Guess I should have checked WHO I was logged on as an WHAT permissions I had. Sometimes (actually, a LOT of times) I just gotta laugh at myself. Tongue Tongue
  
Back to top
 
IP Logged
 
Page Index Toggle Pages: 1
Send Topic Send Topic Print Print
‹ Previous Topic | Next Topic ›
 
  « Board Index ‹ Board Top  

Lantica User Forum » Powered by YaBB 2.6.11!
YaBB Forum Software © 2000-2024. All Rights Reserved.

Valid RSS Valid XHTML Valid CSS Powered by Perl Source Forge